Hi,
all the time or at least very often when upgrading webmin modules through the webinterface will fail. When I try to do an packages sync with upgrade again, it states I need to do a:
dpkg --configure -a
first.
Why is that? Anything I do wrong?
dsp
Its still the case:
E: dpkg was interrupted, you must manually run ‘dpkg --configure -a’ to correct the problem.
Why does upgrade don’t run smoothly when triggered via virtualmin webinterface?
Dirk
Its still the case:
E: dpkg was interrupted, you must manually run ‘dpkg --configure -a’ to correct the problem.
Why does upgrade don’t run smoothly when triggered via virtualmin webinterface?
Dirk
Hey Dirk,
I’m not seeing this problem, though I am running into lots of dependency stupidity on my Debian development system (it’s kinda messy since I didn’t know much about Debian when I set it up).
Are there any other messages? I’ve never seen this particular error, and googling turns up nothing.
Its still the case:
E: dpkg was interrupted, you must manually run ‘dpkg --configure -a’ to correct the problem.
Why does upgrade don’t run smoothly when triggered via virtualmin webinterface?
Dirk
Hey Dirk,
I’m not seeing this problem, though I am running into lots of dependency stupidity on my Debian development system (it’s kinda messy since I didn’t know much about Debian when I set it up).
Are there any other messages? I’ve never seen this particular error, and googling turns up nothing.
Hi Joe,
do you upgrade virtualmin through virtualmin webinterface itself? It just stops with the output at a certain point… Trying to redo causes the message mentioned.
I then enter the shell do the command and everything is fine.
Dirk